Metal Repair Glue，Strongest Glue for Metal to Metal，Suitable for Metal，Stone, Plastic, Aluminum, Steel, All Purpose Repair Glue，Liquid Metal Filler，epoxy，Weld，Heavy Duty, Waterproof,1.6oz

The pipe from the inside wall to the shower head broke from corrosion. I could not remove the threaded side of the pipe inside the wall so I tried to cut it out, but in doing so. damaged the galvanized nipple it had been threaded into. It was either find a way to seal it, or open the wall to replace that nipple. Tried pipe putty and pipe tape but neither worked. So my only hope was epoxy. Mixed it easily (the two tube dispenser worked well), applied it to the inside of the nipple and the new shower pipe, threaded the new pipe into the nipple and let it cure. No leaks! So grateful that I didn't have to cut open the wall! Liked the two tube design the ease of mixing. It was easy to apply with enough time before hardening, and it WORKED! Great value vs the work and expense to cut open the wall and replace parts.

Works fine

Just finished up converting my 24 Maverick Hybrid to a Toad for our RV. I needed to make a custom mounting bracket for the 6 pin plug and breakaway switch. It was difficult to get self tapping screws to hold as the Demco baseplate was hollow. So I used this adhesive to add some additional holding power to the set screws and brackets. Trust me when I say this stuff is stronger than those screws. Within a few house these setup permanently and very strong. Gave them a quick coat of black spray paint and very pleased the way they turned out. Hope they stand the test of time.

Does not dispense properly. Had to dispense individually then mix. Adhesive quality is good but have had same result with JB Weld.

The adhesive itself is very very good. However unlike JB Weld. The injector is not attached to the unit itself. WithJB WELD you can dispense your adhesive and retract the plunger. This sucks the adhesive back into the tubes. With this adhesive you are unable to do that. So adhesive keeps pouring out. ABSOLUTELY WASTEFUL!

I used it to fill in a low spot on a hit and miss engine. Worked like a champ.

I recommended! I had a chair that was broken in the legs and this glue helped.

Used this product to hold .6mm x 1" x 1/2" stainless steel plates in place to build copper coils around. Used it between all plates and adhered them to my boarding. BROKE FREE as soon as I applied pressure! The plates even separated from each other! Junk, had to use FlexSeal..worked!