2pcs PS4 Controller Battery,2500mAh High Capacity (2015 and Before) Old Version Big Flug Compatible for PlayStation 4 CUH-ZCT1E CUH-ZCT1H CUH-ZCT1H/B CUH-ZCT1H/R CUH-ZCT1U with Repair Tools

My controllers last a long time now

2 controllers i had weren't charging. I ordered 2 of these. one was a direct fit and the other had a different connector. I just used the one off the old battery. 3 months later and they still work good.

Holds charge well and fit great.

One battery operates perfectly but the second battery will not hold a charge no matter how long it’s been on the charger..

AS it will take time to actually review these I can only state that you make sure which connectors your controller uses as there are two different types. I had to make some modifications as I purchased the wrong type (wrong connector), Other than that issue they are at this time as advertised.

I needed the battery with the bigger connector (4.5mm) and I had to carefully with a metal finger nail file, file the 2 nibs off the connector, that are to the left and right side of the spine (photo of red wire loop touching original connector) and lightly file all four flat sides except the ends, if you do not file the connector it will go in too tight and will not come off. Also the battery I purchased is slightly thicker then the original, therefore I had to remove the battery tray inside the controller (2 tabs- top left and top right). As far as the actual battery itself, it came fully charged.

It's been a few weeks since installing this to try to give new life to my old PS4 controllers. So far, I don't have any complaints. I game every other night or so for a couple of hours using the controller, and I only have to charge every few days now as opposed to almost daily. The install wasn't too challenging. I would recommend using pieces of plastic like guitar picks to help separate the pieces of the controller.

I’ve been happy with this battery replacement. This one has the larger connector, so you need to verify the model number before hand. The tools that came with it work. I liked the pry tool but the screwdriver was a little rough on the hands but it’s functional. Taking apart the controller isn’t to hard, I started by prying the bottom handles and working up to the R and L top. Once apart just gently remove the battery connector and battery and plug the new one in. Then just re-assemble. So far the battery has been charging well and holding a charge. I do recommend this battery as it’s a good fit, works well and costs a fraction of a new controller.