Arrow Sheds FB1014 Floor Frame Kit for 10'x11', 10'x12', 10'x13' & 10'x14' Arrow Sheds

Arrived undamaged. Very easy to assemble and saved a lot of work over building a traditional floor. Assembly using only tabs was very loose. I used left over sheet metal screws from building the shed to fasten the floor frame together which resulted in a much sturdier feel. After installing plywood (make sure your cuts are precise), the floor moves a bit but the more weight on it the less it moves. I built my shed on a gravel pad to avoid pulling a permit so this was a perfect solution.

This is a complete waste of money it is so weak that when I open the box most of them were bent from shipping. So please don't spend your money you would be better off building it from wood like we had to do anyway

Total waste of money.. Holes dont line up, the metal is so thin and cheap you can literally poke your finger through it. The directions were written by a third grader. The little bit that I did get together I took apart and stacked it up for the Trash Man. Total waste of time and money.

This only fits together by having tongue-in-groove. It does not bolt or screw into itself or the shed. All the real fastening and structural integrity is done by the plywood you put over top. Frankly I was a bit disappointed.

The instructions were a little confusing. The shorter, center cross beams were too long. So I just caddy-cornered them. All in all, the floor framing worked out fine.

This is quite simple to install but fits terribly and is not that helpful.

I does the job it was intended to. Hundreds of bolts and screws to put in and luckily I stare at blueprints all day at work so I could understand the directions. I got the floor kit also and that in my opinion is a must by because it is a lot less stable without a floor in it. But overall its doing the job. Took about 14 hrs from start to finish. Would be impossible by yourself.

Asy to assemble,, but Didn't fit inside my versa tube shed as shown

Bought the floor frame kit to go with the shed I bought. It was a waste of money. It didn't fit and I never used it.

Kit is functional but having gone through the pain of installing it, would not go this route again. I would build a proper wooden frame instead of using this kit.

Fit perfectly and easy to assemble.

Not bad bent easily