Rubber Edge Trim, Self-Adhesive Rubber Edge Trim, Edge Protector for Sheet Metal, EPDM Material, Fit 1/16"(1.6mm), Length 10Ft, Black Color, U Channel Edge Trim

This rubber edging was exactly what I needed for my project. The quality is impressive—very durable and well-made. Installation was quick and straightforward. While it fit securely on its own, I chose to reinforce it with a bit of super glue due to the frequent movement of my project, and it has held up perfectly. Shipping was fast as well, which was a great bonus. Highly recommended!

Great product. I placed this on the top of a snake fence that goes across one of my gate entrances. The snake wire was rough and would catch our outdoor curtains and cut little fingers if they grabbed the gate while opening it. This product lined the top, looks great, fits well, appears to be stable and the adhesive area is working and seems stable. It was a little tricky to put on but well worth the time and money.

Easy to use and worked perfectly

I purchased this to run around some corrugated sheet metal I was using as a heat shield. Thanks to the self-adhesive, this stuck to the metal perfectly, and has made the otherwise sharp edge much safe to work around.It's worth noting that it has held up to heat very well. It sits about 10 inches from a large pottery kiln, and has not shrunk or come away from the edges of the sheet metal after multiple kiln firings.

I put this on the bottom lip of a heavy steel table to protect floors. No complaints about consistency, fit, adherence, etc. but the red tape protecting the adhesive does seem to shrink with temperature changes resulting in it pulling off in places. This was a minor annoyance that didn't impact application beyond sometimes having the tape on the wrong side which required peeling off the trim and resetting. Think this happened 3 times on 8 linear feet.

Work well on my plywood edges for mattress deck in rv.

The bed platform in my camper is 3/8 inch plywood with raw sawn edges. Not a problem until you have to walk around the bed with shorts on. I couldn't figure out why I was getting scrape marks on my legs just below the knee, until I realized they were coming from the rough edges on the bed platform. This trim was inexpensive, fit perfect, installs easily, and adhere very well. I'm looking forward to having no more scrapes from that bed platform.

These were easy enough to install. 10' was plenty to give good coverage on all 4 doors. I had bought some several years ago for my older truck so I have something to compare it to. The other ones I purchased didn't have the adhesive but a little deeper channel so that they went on and stayed on. The adhesive made it a little trickier to install. Also it didn't conform around the door edge perfectly so I feel like dirt will get in easier. With that said, with dirt getting in you will need to remove the rubber to clean the door and since there is adhesive I'm not sure that you will be able to put it back on which is why I think I liked my older set better. Even though it didn't have adhesive it would stay on, I could take it off to clean and easily install back on. I also have some contours in my door edge and in those particular areas it didn't have good form fitting. After a few days of being on it has held well and looks good. I'd recommend because it will help from leaving a door ding the car next to you when your kids get out and the door gets away from them but I feel the product could be a little better.